Bring part data to a tube bender quote, not just a tube size. A supplier can only match a machine to your work when it sees the material, the geometry, the volumes and the tolerances you need to hit. The more detail you bring, the better the match.
Start with your five highest-volume parts and your single hardest part. Those six parts usually define the machine.
Part data
| Item | Why it matters |
|---|---|
| 3D model or drawing of each part | Shows every bend, angle and straight length in one place |
| Material grade and temper | Sets the force needed and how much the tube springs back |
| Outside diameter and wall thickness | Sets machine capacity and tooling size |
| Centerline radius of each bend | Each radius needs its own tooling. Several radii in one part may call for a multistack machine |
| Number of bends and bend angles | Drives cycle time and the number of axes you need |
| Shortest straight length between bends | Rotary draw benders need a straight section to clamp on |
| Tolerances | Angle, length, ovality and wall thinning limits decide whether you need a mandrel and how precise the machine must be |
| Surface finish requirements | Visible or plated parts may need special tooling to avoid marks |
| End forms and secondary operations | Flares, beads, cutting and punching can be combined with bending or done in a cell |
Volume and production data
| Item | Why it matters |
|---|---|
| Annual volume for each part | Decides how fast the machine must run and whether automation pays |
| Typical batch size | Small batches make setup time matter more than cycle time |
| Number of part numbers | A high mix favors stored programs and fast changeover |
| Parts you expect to add in two to three years | Keeps you from buying too small |
| Current problems | Scrap, rework or supplier issues point to the features that matter most |
Site details
- Floor space, including room to load full-length tube and unload finished parts.
- Available power, voltage and phase.
- Compressed air supply.
- Floor condition, and whether a large machine needs a foundation.
- Door sizes and crane or forklift access for delivery.
Budget and timing
- A budget range, including tooling, software and installation.
- Your target date for first production parts.
- Whether you plan to buy, lease or finance.
Bring sample tubes
Keep a few lengths of tube from the same material you will run in production. A test bend on real material answers questions no drawing can.
Common questions
Do we need 3D models?
They help most, but drawings work too. If you design in SOLIDWORKS, software can pull bend data straight from the model. See from SOLIDWORKS design to bend data.
How many quotes should we get?
Get at least three, and compare them line by line. Make sure each one covers the same tooling, software, installation and training.
Should we include parts we do not make yet?
Yes. Capacity is one of the four levers in choosing a bender. Plan for your largest likely part, but do not pay for capacity you will never use.
Send it to ITEC
Send this information to ITEC and we will review the application before recommending anything. With machines from six manufacturers, we can match the part to a Best-Fit Bender. Book an introductory meeting.
