Skip to main content
Software and Automation

When to Automate With a Robotic Bending Cell

Automate a bending cell when you run steady volumes on repeat parts and labor, not machine speed, limits your output. Start with automatic loading and unloading. Add a robot for handling and secondary operations once your parts, tooling and corrections are proven.

Signs automation will pay

  • The bender waits on an operator to load the next tube.
  • One person spends the shift loading and unloading instead of checking parts.
  • Parts go to a second station for cutting, end forming or inspection.
  • You cannot hire enough operators for the shifts you need.
  • Downstream processes such as robot welding need consistent parts.

Levels of automation

Level What it adds Good fit when
1. Manual loading An operator loads and unloads every tube Low volume or very high mix
2. Automatic loader A magazine feeds tubes into the machine Long runs where loading limits output
3. Automatic unloading Finished parts are removed and stacked or dropped into bins Parts that are easy to collect and count
4. Robot handling A robot loads, unloads and presents parts to the next step Heavy or awkward parts, or parts that must be placed precisely
5. Full cell Bending, secondary operations and inspection in one guarded cell High volume part families with stable designs
Herber 1100S in a fully automated bending, forming and cutting cell. Bending, forming, cutting and inspection all run in one cell. That is level 5 in the table above.

What one operator can run

ITEC has worked with Star Technology and MTS to build work cells that let a single operator bend and process tubular parts safely, reliably and efficiently (ITEC case studies). At Briggs & Stratton, consistent parts from a twin-head bender also made the robot welding downstream run more smoothly (ITEC case studies).

Prove the process first

Automation repeats whatever the process does, good or bad. Before adding a robot, make sure these hold steady.

  • Parts bend within tolerance across batches and material lots.
  • Springback corrections are stored and stable.
  • Tooling setups are standard and documented.
  • Incoming tube is consistent in length, diameter and straightness.
  • Designs are not changing every week.

Plan the cell around the part

  • How will each tube be presented to the machine?
  • How will the robot grip a bent part without marking it?
  • Where do finished parts go, and how are they counted?
  • Which secondary operations belong in the cell?
  • How will people enter the cell safely to change tooling?

Common questions

Robot or dedicated loader?

A dedicated loader is simpler and cheaper for straight tube feeding. A robot earns its place when parts need handling after bending or must move between several operations.

Herber 350RL all-electric bender with integrated robotic load and unload. Here the robot loads the tube and takes each finished part away from the machine.

Can a cell handle a high mix of parts?

Yes, but it is harder. Stored programs, multistack tooling and quick-change grippers help. Start with your most stable part family.

Do we need a robot programmer on staff?

Someone on site should be able to make small changes and restart the cell. Larger changes can come from your supplier or integrator.

Plan a cell with ITEC

ITEC can scope a cell from a single loader to a full line, and tell you plainly whether automation will pay for your parts yet. Book an introductory meeting.

The World’s Largest Range of
Tube, Pipe & Profile Bending Machines