Aluminum profiles distort when the alloy, the tooling and the bending method are not matched to the shape of the section. Start with an alloy and temper that will bend, support every thin wall through the bend, and choose a machine built for the profile you are bending.
Why profiles are harder than round tube
A round tube is the same in every direction. A profile is not. Flanges, thin webs and hollow chambers each react differently as the section bends.
- Thin flanges on the inside of the bend buckle or wrinkle.
- Hollow chambers collapse without support.
- Non-symmetrical sections twist as they bend, since the force does not pass through the section’s center.
- Aluminum springs back more than steel of similar strength, because it is only about a third as stiff.
- Visible and anodized surfaces mark easily.
Problems, causes and fixes
| Problem | Likely cause | Fix |
|---|---|---|
| Twisting | Non-symmetrical section, or tooling that does not hold the profile | Tooling shaped to the profile, plus a machine that controls twist during the bend |
| Buckled or wrinkled flange | Flange unsupported on the inside of the bend | Tooling that supports the flange, or a larger radius |
| Collapsed chamber | Hollow section unsupported | Inserts, fillers or a mandrel shaped to the chamber |
| Radius or angle off | Springback, which varies with alloy, temper and lot | Overbend correction measured on real parts, and consistent material |
| Cracks | Temper too hard for the radius | Bend in a softer temper and age afterward, where the specification allows |
| Surface marks | Tooling contact on a finished surface | Polished or non-marking tooling, protective film and the right lubricant |
Choosing a bending method for profiles
- Roll bending suits large-radius arcs, such as architectural and window profiles.
- Stretch bending pulls the profile while forming it. It holds shape well on large radii and is common for trim and structural parts.
- Rotary draw with profile tooling suits tighter radii, with tooling made to fit the exact section.
- Machines built for non-symmetrical profiles control the section in more than one direction, which keeps complex shapes from twisting.
Practical steps before production
- Send the profile drawing and the alloy and temper to your supplier early.
- Test bend samples from the same extrusion supplier and lot you will use in production.
- Decide whether parts are bent before or after anodizing or painting.
- Agree on how twist, radius and surface will be measured and accepted.
Common questions
Can anodized profiles be bent?
Sometimes, but the coating can crack on tight radii. Where possible, bend first and finish afterward.
Why do two batches of the same profile bend differently?
Extrusion tolerances and material properties vary from lot to lot. Consistent material from one supplier and a machine that corrects from measured parts keep results steady.
Does a profile need its own tooling?
Usually, yes. Each profile shape needs tooling that fits it closely. Plan tooling cost and lead time into the project.
Bend profiles with ITEC
ITEC represents Thoman, which specializes in bending machines for non-symmetrical aluminum profiles and builds them around each customer’s sections. Book an introductory meeting and bring your profile drawings.
